KINGSTON MEMORIA 8GBDDR4 2400MHZ HYPERX FURY BLACK

54,93

SKU: HX424C15FB2-8 Categorías: , , ,

Descripción

*Power will vary depending on the SDRAM used.
HX424C15FB2/8
8GB 1G x 64-Bit
DDR4-2400 CL15 288-Pin DIMM
Continued >>
kingston.com/hyperx
FEATURES
HyperX HX424C15FB2/8 is a 1G x 64-bit (8GB) DDR4-2400 CL15
SDRAM (Synchronous DRAM) 1Rx8, memory module, based on
eight 1G x 8-bit FBGA components per module. Each module
supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0.
Each module has been tested to run at DDR4-2400 at a low latency
timing of 15-15-15 at 1.2V. Additional timing parameters are
shown in the Plug-N-Play (PnP) Timing Parameters section
below. The JEDEC standard electrical and mechanical
specifications are as follows:
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command Time (tRFCmin)
Row Active Time (tRASmin)
Maximum Operating Power
UL Rating
Operating Temperature
Storage Temperature
15 cycles
46.75ns(min.)
350ns(min.)
29.125ns(min.)
TBD W*
94 V – 0
0o
C to +85o
C
-55o
C to +100o
C
JEDEC/XMP TIMING PARAMETERS
• JEDEC/PnP: DDR4-2400 CL15-15-15 @1.2V
DDR4-2133 CL14-14-14 @1.2V
•XMP Profile #1: DDR4-2400 CL15-15-15 @1.2V
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP – 2.5V Typical
• VDDSPD = 2.2V to 3.6V
• Nominal and dynamic on-die termination (ODT) for
data, strobe, and mask signals
• Low-power auto self refresh (LPASR)
• Data bus inversion (DBI) for data bus
• On-die VREFDQ generation and calibration
• Single-rank
• On-board I2 serial presence-detect (SPD) EEPROM
• 16 internal banks; 4 groups of 4 banks each
• Fixed burst chop (BC) of 4 and burst length (BL) of 8
via the mode register set (MRS)
• Selectable BC4 or BL8 on-the-fly (OTF)
• Fly-by topology
• Terminated control command and address bus
• Height 1.340” (34.04mm), w/o heatsink

http://www.kingston.com/datasheets/HX424C15FB2_8.pdf

Valoraciones

No hay valoraciones aún.

Solo los usuarios registrados que hayan comprado este producto pueden hacer una valoración.